How was that finish obtained? Here I think is the answer from the official US Army source. The surplus oil should be wiped off and the stock polished with a clean dry cloth or the palm of the hand.Ībout once a month apply OIL, linseed, raw, with a CLOTH, wiping, to the wood. The stock and hand guard or barrel guard should be removed from the barrel and receiver for such oiling." (, page 104)Ĭare must be exercised not to allow the oil to get into the mechanism of the rifle as it will harden and prevent functioning. The book also contains a reprint of the article "Overhauling the Service Rifle," by Lieut. A., from Army Ordnance, July-August, 1928, Vol. "The repairs found necessary on the stocks and handguards are. and the patching of sections which have been badly cut or bruised. The stocks and handguards which have been accepted after the necessary machining operations have been performed are scraped, sanded and immersed in raw linseed oil and allowed to remain in the oil about five minutes, after which they are removed and allowed to dry." Small cuts and bruises are filled with shellac or a mixture of shellac and sawdust. (As I was finishing this article, I saw the following post on Tuco's Collectors' Forum. Army about once a year on a nice afternoon we (platoon) would scrape the old finish from our Garands (w/broken glass), bone the wood to close the grain & reapply linseed oil.This procedure had been done forever & probably accounts for some cases where metal looks better than the wood. So that "refinished" stock you see may actually be original and not refinished.) It sure removed proofs & cartouches …" It's not unreasonable to assume that other armies also followed similar practices. What I would like to find is the equivalent information in official Japanese Ordnance publications.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |